Protective cover for drills according to occupational health and safety 172mm

Protective cover for drills according to occupational health and safety 172mm
Protective cap for drills according to occupational health and safety regulations
Trumps:
Telescopic protective cover, vertically adjustable, see "B" and "C".
Shielding not only of the spindle, but also of the tool
Protects the operator from direct frontal contact with rotating parts of the spindle, the tool, chips and from lubricant and coolant splashing away.
Polycarbonate screen
Equipped with 180° rotating microswitch with 2 NC contacts, positive contact
Suitable for:
Table and column drills
Delivered with:
CE mark
CE certificate
Instruction / assembly manual
Attention: this type of protection requires adjustments to be made in order to mount on your column drill. A safety shield must be installed by qualified personnel. The estimated working time is approximately 2 hours, provided there is an emergency stop circuit. In case of questions or installation, you can always contact our technical department.
Tip: When choosing the shielding, you should take into account the drilling depth, as well as the width of the spindle, which should be shielded, and also the safety of the operator.
A mm 172
W mm 180
Slot depth mm 180-300
D mm 114
E mm 230
Weight kg 3.70

Contact:
Tel:0031-111-795029
Whatsapp:+31-111 79 50 29
eMail:Klantenservice@Xenon2Go.Com