Beral Uni-Stick Repair stick aluminum

Beral Uni-Stick Repair stick aluminum
Description
Uni-Stick aluminum
Application:
To be used as putty. Fills holes, scratches, cracks in tank containers, drums, pipes, etc. Can be quickly formed and easily modeled. Suitable for drilling, sandblasting, sawing and can be dyed over. Adheres to most surfaces such as metal, wood, plastic, concrete and ceramics, even on damp surfaces. Uni-Stick Aluminum can also be used under water.
Instructions:
The parts to be repaired must be clean, free of oil and grease. Knurling increases the firmness. Mix / knead the required amount of the stick for about 2 minutes until a uniform color is obtained and the material becomes hot. Then do stick on the parts and the model. Mechanical processing can be done after approx. 20 minutes. Do not use under an outside temperature of 5 ° C. Temperature resistant from -50 ° C to 180 ° C, short-term to 300 ° C processing time approx. 3 - 4 minutes. Hand strength 8 to 10 minutes. Final strength after 24 hours.
Extra information:
Kneading / mixing for 2 minutes
Mechanical processing after 20 minutes
Do not use under -5 ° C
Temperature resistant: -50 ° C to 180 ° C
In the short term 300 ° C
Hand strength: 8-10 minutes
Final strength after 24 hours